If the drain leak icemaker wire is positioned correctly and is turned on proceed to check the freezer temperature. The temperature should be within the range of 0 to 8 degrees Fahrenheit. If it's above 10 to 12 degrees, your machine will not produce ice.
Water leak detectors are alarms that alert you of leaks. They do not stop the water leak from happening. They also do not stop the leak after it happens or turn off the water line repair valve. You will still need to turn off the water valve yourself and contact a Utah plumber to come check out the plumbing issue.
After you have the stems out you should be able to find the washer on the "inside" end. If it is nicked, torn or brittle it is likely the cause of your drip. Even if it looks brand new, go ahead and replace it. You've already come this far. You can get replacement washers at almost any hardware store. Sometimes you may want to replace the whole stem, especially if the handle end is stripped out. It's best to just take the stem with you to the store and see if you can match it up. Most Do It Yourself stores have replacement stems for many popular brands. If your valve has a center diverter valve to switch the waterfrom the tub spout to the shower head the same process applies. Many times it is easier to replace the diverter stem than to repair it. This really depends on the design of the stem.
Once you have disconnected the tank remove it from your work space. Do a thorough measurement of the remaining pipe for reference when you go to the hardware store. I will be honest with you, you might need to make a few trips back to the store. Once you get the new tank, slide it into place to line up the plumbing.
Keep an eye on any leaks in and around the house. Inspect taps, pipes and your roof regularly. Watch for leaks and if you find them, get it water line repair as soon as possible.
The way a toilet plunger works is by filling up with water and then pushing that water through the stopped up drain. When unclogging a clogged toilet, the idea is to plunge up and down a couple of times so the plunger fills with water and then jam the open end, sometimes called a force cone, into the waste outlet in the plugged toilet and start plunging. You may have to pump the plunger up and down several times to clear the blockage.
A large plumbing job, such as re-piping or installing additional fixtures, may require a permit. Check with your city's department of building and safety before asking for estimates, and avoid any plumbers who are reluctant to comply with regulations.